17
D22000417 v.2 - UPD 030706
3 - SAFETY
The information given in the chapter is extremely important for safety purposes. It describes possible hazards tied to use of the machine and
instructions for correct use of this to avoid injury or damage.
WARNING
: This log splitter has been designed and manufactured to split logs of the sizes recommended only (fig.2 page 2).
Use of the machine for any other purpose shall be considered improper and the manufacturer shall not be liable for any injuries or damage
to be ascribed to improper use of the machine.
The operator must operate the machine drive control with both hands without using other improvised systems and without tampering with
the controls
.
When the machine is working, persons and animals must be kept at a distance of at least 5 meters from the machine.
For the best and safest use, the log splitter should be used on a raised surface of height between 60 and 75 cm.
NEVER ATTEMPT TO TAMPER WITH THE PROTECTIONS OF THE LOG SPLITTER OR TO OPERATE THE MACHINE WITHOUT THESE. FAILURE
TO COMPLY WITH THE INSTRUCTIONS GIVEN IN THIS CHAPTER MAY RESULT IN SERIOUS INJURY OR DAMAGE TO PERSONS, THINGS
AND TO THE MACHINE.
3.1 - General safety regulations
•
The machine must always be used by one operator only.
•
Do not use the machine outdoor when it is raining or snowing.
•
Nobody must be allowed to use the log splitter unless they have read the instruction manual and have been instructed in the regulations to follow
for correct and safe use.
•
The machine must be used by adults only. Use of the log splitter by apprentices of not less than 16 years of age must be supervised by an adult
authorised to use the machine.
•
Never wear loose, unbuttoned clothing which may become trapped in moving parts.
•
The working area must be free from any objects that could prevent complete freedom of movement for the operator while working.
•
Keep the log support bench free of waste materials (9 in fig.1) and ensure that the operators work space is free of obstacles: logs, chippings,
sawdust, etc.
•
Check that the logs to be split are free from nails or wire, which may fly up or damage the machine. the ends of the logs must be cut square.
branches must be cut off flush with the trunk.
•
Never try to split logs larger than those indicated in fig. 2. This could be dangerous and may damage the machine.
•
Break wood in the direction of the grain. do not place wood across the log splitter and leave it in that position for splitting; it may be dangerous and
may seriously damage the machine.
•
Never attempt to cut two logs at once; one may fly up and hit you.
•
If the log moves away from the blade, retract the ram or the blade and turn the log through 90°.
•
Do not attempt to load the log in the log splitter while the ram is in motion: you could get trapped and injured.
•
Keep your hands well away from any splits and cracks which open in the log; these may close suddenly and crush or amputate your fingers.
•
Do not force the blade by pushing the log on the upper part (fig.9), as this can cause the blade to break or damage the body of the machine. Always
set the log on the guides.
•
Never leave the machine unattended while it is running. If you leave the machine, even for a short time, remove the power supply or any possible
cause of accidental start-up.
•
The log splitter must never be used by an operator who is under the influence of alcohol, drugs, medicines, or who is tired. A clear mind is essential
for safety.
•
Never request the assistance of another person to help you remove a jammed log.
•
Do not use machines with electric motor if natural gas, petrol fumes or other inflammable vapours are present.
•
Check that the electric circuit to which the machine will be connected is suitable
.
Power, voltage and frequency of the motor must
be checked (verify the nameplate on the motor and the data in this manual). The machine must be connected to a circuit with a regulation
differential switch upstream and, in compliance with the norms
(30 mA rated fault current)
, with a ground connection.
•
Use cables with a section of 2.5 mm2. Avoid use of free and inadequately insulated connections. Connections must be made with protected
material suitable for outdoor use.
Do not use cable extensions longer than 5 mt.: too long cables or cables with inadequate
section may cause voltage drops and dont allow the motor to develop all the power.
Always check the cable extension for any damage before using it.
•
Never open the pushbutton box on the motor. Should this be necessary, contact a qualified electrician.
•
Make sure that the machine and the cable never come in contact with water.
•
Treat the power cable with care. do not attempt to move the machine by pulling the cable. do not yank the cable to unplug it; keep the cable away
from excessive heat, oil and sharp objects.
•
Never leave the machine unattended with the power supply on. After use, always switch the machine off and disconnect it from the power
supply, especially when any maintenance work is required.
•
Do not use alcohol, petrol, or solvents to clean the machine. This could cause the safety information applied to the machine itself to become
illegible.
ENGLISH
