P
a
n
chromatic
Bell & Howell 606 Gaumont (H)
User Manual
8
www.Panchromatic.co.uk
Inserting the Lamp
Turn the tilt knob (Fig 2
13
) clockwise until the projector is
tilted fully forward. Unscrew the bakelite cap below the lamp
housing (Fig 1
2
) and insert the projector lamp with the vertical
tongue at its base towards the front of the projector. Rotate
slightly so the tongue passes through the pre-alignment slot in
the lamp house, when the lamp can be pushed home out of
sight. Now the lamp is in position, replace the lamp house cap.
Focusing the Projector
First ensure that both the motor and lamp switches (Fig 1
1
)
are in the OFF position then, insert the rubber covered mains
plug into the socket (Fig 1
20
). This plug will only fit in the
correct position as the locating pin is offset. Now plug into the
electrical supply. Switch on the motor and lamp and then move
the clutch Fig 1
18
) to the RUN position. The motor will operate
and a beam of light be projected.
Move the projector on its stand or table to a position where the
light falls squarely onto the screen, using the tilt control (Fig 1
13
) to either raise or lower the picture area. To adjust the size
of the picture area move the projector nearer to or further
away from the screen as required.
