1
2
3
4
5
6
7
8
9
10
16
Using your PRO2 PS/2
se
ct
io
n
3
Powering up the Systems
Once all cables have been connected, power up the computers that
are attached to the PRO2 PS/2. All computers can be powered on
simultaneously. The PRO2 PS/2 emulates both a mouse and keyboard
on each port and allows your computer to boot normally.
The computer connected to port “1” will be displayed on the monitor.
Check to see that the keyboard, monitor, and mouse are working
normally. Proceed to do this with all occupied ports to verify that all
computers are connected and responding correctly. If you encounter
an error, check your cable connections for that computer and reboot.
If the problem persists, please refer to the Troubleshooting section in
this manual.
Using Your PRO2 PS/2:
Now that you have connected your Console and computers to your
PRO2 PS/2, it is ready for use. Select connected computers by
either the direct-access port selectors, located on the front panel of
the PRO2 PS/2, using the On-Screen Display, or by using hot key
commands through the Console keyboard. It takes approximately 1-
2 seconds for the video signal to refresh after switching computers.
Re-synchronization of the mouse and keyboard signals also occurs.
This is normal operation and ensures that proper synchronization is
established between the Console and the connected computers.
