Belkin F5D7130 - Wireless G Access Point, User Manual

Page: 34 / 38

54Mbps Wireless Access Point User Manual
24
1. In the Locate New Firmware field, click Browse to locate the
firmware file.
2. Click the Upgrade button to start upgrade and then wait for a
few minutes as the utility prompts. You will return to the
Administration page while the process is complete.
Note: Do not interrupt the upgrade process otherwise it might
cause damage to your 54Mbps Wireless Access Point.
After upgrade, you can see the new firmware version in Current
Firmware version field.
υ
User Configurations
Save Current Configurations: Allows you to save your
customized settings to the device. Once your router is properly
configured, you may wish to save current settings. The saved
settings can be retrieved easily if required, even after you reload
factory defaults.
Retrieve User Configurations: If you have loaded factory defaults
(either via the Load Default button on the back panel or via the
Restore button in this group), you can restore your settings by
clicking the
Retrieve button.
Important: After retrieving your desired configuration file, you must
reboot the device to enable the retrieved settings.
Restore Factory Defaults: To restore factory defaults, click the
Restore button and then wait for a few seconds as the utility
prompts. You will return to the Administration page while the
process is complete. This feature is basically the same as resetting
via the Load Default
button (see “Rear Panel and Connectors”) on
the device but it allows you to remotely perform the reset task.
υ
System
Reboot: This option allows to you remotely reboot the device.