KG8 3/8”
KG6, KG10A ¼”
SH8
(not shown – see picture page 9). Push-rod for KG6 & KG8 ball joints. 5/16” 36” long
Use SH10 3/8” rods for GMB and dual FSAF or FSNF linkages. 5/16” can bend under heavy
loads.
ZG-DC1
Damper blade clip and ball joints for blades typically
3.5” in width. Typically the actuator or rod to shaft
is in front of blade.
ZG-DC2
Damper blade clip and ball joints – typically used for 6” wide
blade control dampers. Typically the ctuator or rod to
shaft is above or below the damper.
Negator spring hybrids
There are some models of dampers that mix negator springs and fusible rods with the Phillips
motors. Call for assistance. Photos will be needed to identify exact procedures. See also:
Ruskin Phillips P150 to Belimo FSNF or FSAF March 2018
13
