Technical Manual WD 230 and WD 250
Rev. 1.8 PF
Page 32
73018_E rev 1 8-Technical Manual.doc
4.6.8 At Program end, CS door opens automatic
(2 doors = CS; 1 door = UC)
Default = OFF, with conveyor always ON.
Door open at progr. end
ON
/ OFF
4.6.9 Door Interlock Unclean Side:
If a program got interrupted with the I/O button, during a program
cycle, the UC door stays interlocked. On the display instead of “Pro-
gram ready” “Door Interlock” is shown. The Door can be opened
only if a program is run successfully till to the end.
Default = On
Door Interlock
On / off
4.6.10 User Identification
Input of name No. by means of keyboard or input name by means
of barcode reader for batch documentation.
IN case of activated user ID, name or number of user will be inter-
rogated on display as follows: “User Name or No.?.."
The machine either enters a two-digit number of the 6 program but-
tons from 11 – 66 or reads a text by means of the barcode scanner.
The respective number (e.g. 36) or name is fed to the printer
RS232 X 31 or interface RS 485 X32. A program can be initiated
only if this input is completed. If program start is attempted, the ma-
chine will remain in the interrogation mode. In case of automatic
basket loading, program cannot be started until this information is
provided. Upon entering a 66, text "No ID" will be passed on.
Barcode reader is connected identical to printer to the printer inter-
face X32.
Default = Off
User Identification
on / off