BELGACOM Forum 523, Mounting And Commissioning Manual

Page: 148 / 244

Configuration 146
DECT over IP
®
of radio waves in accordance with the IEEE 802.11b/g standard.
This standard enables a wireless connection to be made to an Eth-
ernet network (LAN) using suitably equipped user terminals. Data
transfer via radio waves is very fast. Depending on the conditions
of the operating environment, it can reach speeds of up to 54Mbit/
s (gross).
WLAN settings are configured centrally for all Access Points using
a separate Web configurator, which can be found at the IP
address of the DECT over IP Manager. You can reach this address
by entering the IP address of the DECT over IP Manager directly
into the address bar of your Web Browser. Alternatively, you can
also go to the
Configurator , to the page Telephony: Devices:
DECT over IP and click on the WLAN Config. button. Log in
under the User Name “Administrator” and enter the same pass-
word as for the Forum 523/524.
DECT over IP/OpenMobility Managers Login Page
The WLAN function and the function of the DECT over IP Manager
cannot be used simultaneously on the same DECT over IP base
station, so you will always need at least two DECT over IP base
stations. The WLAN settings are then made as follows:
1. Set up the existing DECT over IP base stations in
theForum 523/524’s Configurator . Go to the DECT over IP
Manager’s Web Configurator.
2. On the WLAN Profiles page, configure at least one set of
settings (see below under: Setting up a WLAN Profile ). Note
down the password you have used (“Pre-Shared Key”), so that
you will be able to use it again later when setting up wireless
user terminals or notebooks.