15
Mounting instructions - mechanics
13. Mode of operation
The device is operated electromechanically. A 12 V DC motor drives a shaft. A
driving rod attached to the screw nut pushes the shaft out of or into the drive unit
thus moving the gate. As soon as the operator reaches the end positions which
have been set before it automatically stops by means of the end switches.
When the wings of the gate exceed 2 m or a gate is provided with two wings it is
recommendable to mount a stopper in the position “GATE CLOSED”. To have an
additional locking device, you can install an electronic lock.
The operator is self-locking. When the gate is locked (normal operation), it is not
possible to open it manually without doing damage to the operator or the sheath-
ing. If the self-locking capacity of the gate is insufficient, you have to install an
electronic lock in addition.
14. Scope of delivery
(1) 1 x Instruction manual
(7)
2 x cotter-pin 3,2 x 20
(2) 1 x operator Jupiter 250
(8)
1 screwdriver small
(3) 1 x sheathing for gate wing
(9)
1 button cell 3 V
(4) 1 x sheathing for pile
(10)
1 x clamp
(5) 1 x hexagon bolt M10x40
(11)
1 x maintance log book
(6) 1 x hexagon bolt M10x45
(12)
1 x silicone aerosol
