32
Installation EAGLE40
Release 02 08/2020
Remove the power connector from the device.
Connect the wires according to the pin assignment on the device with
the clamps.
Fasten the wires connected by tightening the terminal screws.
Signal contact (optional)
Connect the wires according to the pin assignment on the device with
the clamps.
Fasten the wires connected by tightening the terminal screws.
2.4.2
Wiring the digital input (optional)
Remove the power connector from the device.
Connect the wires according to the pin assignment on the device with the
clamps.
Fasten the wires connected by tightening the terminal screws.
2.5
Operating the device
Pin
Signal, terminal
Function
1
DI (+)
Signal input
2
DI (
−
)
Reference potential
Table 10: Pin assignment: 2 pin, screwable terminal block (on the left), connection
to the device (to the right)
WARNING
ELECTRIC SHOCK
Before connecting the electrical wires,
always
verify that the requirements
listed are complied with.
See “Requirements for connecting electrical wires” on page 7.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
2
1
Summary of Contents for HIRSCHMANN EAGLE40
Page 52: ......
