MV-841/851 User Manual
Module Fitting Procedure
Hardware Installation
Issue 1 Revision 1
Page 47
© 2020 Grass Valley, a Belden Brand
Refer to
on page 42 for MV-841/851 module fitting slot locations.
Module Fitting Procedure
Please ensure that you have read
, on page 46 before proceeding to fit
modules.
1.
Go to the
rear of the router frame
.
The procedure begins with the fitting of rear modules:
2.
Locate the rear slot pairs for
MV-841/851
fitting.
Refer to
on page 42 for MV-841/851 module fitting locations.
3.
Insert an MV-841/851 Rear Panel module into the rear slot pair.
Repeat for each further rear panel module being fitted.
Check the orientation of the rear module, see Figure 24.
Note:
When inserting a
front
module into a front slot:
•
Check the module is the correct one for the slot.
•
Check there are no obstructions at the module connectors.
•
Check for any high components on the module’s top- or
under-side. Do not knock these during fitting.
•
Insert the module into the slot and slide the module into the
frame.
•
When the module is nearly fully in the frame, gently push the
module levers. See Figure 26
•
In the last few millimeters of travel, the module connectors
mate with the internal router motherboard and its rear panel
module.
Some resistance will be met; ease, but do not force, the
module in with the levers.
•
If excessive resistance is met, remove the module and
re-check that the module and slot are correct. Check the slot
for any obstruction. Check the module connectors for any
damage or foreign objects.
•
In the final few millimeters of travel, the levers engage with
the router frame, locking the module into position
