Belden Grass Valley CopperHead 3404, User Manual

Page: 59 / 113

53
CopperHead 3404
User Guide
Connectors into and out of the CopperHead 3404 Camera Unit Back Side
• 3: Intercom Headset Out
XLR 5 Pin Female Connector - Provides two channels of two-way intercom and the
Intercom Program audio feed.
• 4: Audio 1 & 2 Out
XLR 5 Pin Male Connector - Provides Return Audio Out from camera for Channels 1 & 2.
Typically connected to a local monitor at the camera position.
• 5: Audio 1 In
XLR 3 Pin Female Connector - Line level audio input. Typically fed by short audio
jumper cables from the Camera Audio 1 output (can also take local audio device feeds
from camera position).
• 6: Audio 2 In
XLR 3 Pin Female Connector - Line level audio input. Typically fed by short audio
jumper cables from the Camera Audio 2 output (can also take local audio device feeds
from camera position).
• 7: Camera Remote Connector
Multi-Pin Connector A - 10 Pin Hirose Connector. This is normally a Grass Valley, a
Belden Brand supplied cable. It connects the Camera Unit to the Camera CCU in to
allow operation of the Camera Remote Control Panel. Please see
Available Accessories
on page 90 for a list of available cables.
Power to the Camera Unit & Camera must be turned off when connecting the Camera
Remote Control Panel Cable- connecting with the power on can seriously damage your
equipment.
• 8: Data Connector
Multi-Pin Connector B - DB15 15 Pin Serial Connector. This carries serial control signals
for lens and remote pan & tilt units as well as GPI, Intercom Trigger (GPI) and Tally
signals. Grass Valley, a Belden Brand supplies a number of pre-configured break out
cables for use with this connector (see
Multi-Pin Wiring Suggestions on page 100).
• 9: 4K- 3G/HD/SD SDI Inputs (4)
BNC Connectors - Carries 4K camera video from the Camera to the Camera Unit. This
requires BNC jumper cables between the Camera Unit and the Camera.
• 10: HD/SD SDI Input
BNC Connector - Carries camera video from the Camera to the Camera Unit. This
requires a short BNC jumper cable between the Camera Unit and the Camera.
• 11: HD/SD SDI Outputs #1 & #2
BNC Connector - Carries return video from the Base Station to the Camera Unit.
Typically this will feed a camera viewfinder or an HD viewing monitor at the camera
location.
• 12: VBS In
BNC Connector - Carries SD Analog video from the Camera to the Camera Unit. This
requires a short BNC jumper cable between the Camera Unit and the Camera. Can be
used to provide technical monitoring from camera as with superimposed camera
menus and other information.