FX FUSION SC CONNECTOR
PX106500-EN REV E
Page 7 of 8
900µm TIGHT BUFFER/250µm - INSTALLATION GUIDE
16.
Carefully slide the
splice
protection sleeve
to have a
portion of the buffer cleaved
fiber and the
ferrule stub
assembly
covered.
IMPORTANT:
The splice
protection sleeve must
completely cover the first
portion of the ferrule stub
assembly as shown below.
17.
Place the cable assembly into
the splicer heater and follow the
manufacturer’s instructions and
Belden’s heat settings.
Heat the splice protection
sleeve.
18.
Remove the cable assembly
from the heater after the
shrinkage is completed.
