FX FUSION SC CONNECTOR
PX106500-EN REV E
Page 6 of 8
900µm TIGHT BUFFER/250µm - INSTALLATION GUIDE
12.
Place the cleaved fiber in the
V-groove (on the
right side
) of
the fusion splicer.
NOTE:
The placement of the end face is
important. Fibers end face should be
located in between the V-groove and
electrodes as shown.
13.
Perform the fusion.
14.
Bring the splice
protection
sleeve
close to the splicer.
15.
Open the splice holder and, by
holding the cable and the
dust
cap
, remove the spliced cable
assembly from the splicer.
