Belanger Quad Wave Mitter, Owner'S Manual

Page: 23 / 44

QUAD WAVE MITTER™
1MANUL633
Belanger, Inc. *PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
19
Installation
Cloth
In order to install the cloth, some disassembly is necessary. Pay attention to how the machine is
taken apart.
1) Loosen the upper lock
ing collar on the drive rack with a 3/16” (5 mm) hex wrench and
slide it over against the flat washer.
2) Remove the retaining pin from the upper drive arm on the Pitman arm end and remove
the upper drive arm from the Pitman arm so that the rack hangs vertically
3)
Loosen outside collar using a 5/16” (8 mm) hex wrench.
4) Slide outside collar out a
way from center approximately 4” (10.2 cm).
Front View
Outside
locking collar
(typical)
1-1 /8” (29 mm) bolt
(remove for cloth installation, typical)
Inside locking collar
(typical)
Cloth (typical)
Upper locking collar
Shaft bearing
Outside end plate
(typical)
Inside end plate
(typical)