Attach the panel support bracket into the post with the hex head screws supplied.
The measurement from the top of the post will vary depending if you have Flush or External .
Depending on which join you have, whether its a closed join or a exposed join your bracket height will be
different in height.
Example: for an 1800mm high closed join wall the bracket should be fixed at 1830mm from the top
of the post. This allows for the post top to sleeve over the post after the panels have
been installed. Please Note: if you choose to have the exposed join you will have to add 13mm to get the
required bracket height. (See table below)
The support bracket should be fixed at 5mm more than the finished wall height.
Example: For an 1800mm high closed join wall, the bracket should be fixed at 1805mm from the top of
the post, if it is an exposed join wall, the bracket should be fixed at 1819mm. This 5mm is to allow for the
thickness of the top wall capping and base channel on top of the panel measurements.
Support Bracket
Tek Screw
*We recommend to
go for the exposed
join look as it gives
a far superior finish
to the complete
wall
Finished Wall
Heights (mm)
900 1200 1500 1800 2100
Closed Join
928
1228
1528
1828
2128
Exposed Join*
N/A
N/A
1540*
1840*
2140*
Flush Capping*
-22mm -22mm -20mm -20mm -20mm
Wall Support Bracket Fixing Heights heights
Suggested Cleat Height for your new wall
mm
If you have a wall with Flush Capping, Take 25mm off the above
Heights
7
/ SOLID PANEL INSTALLATION GUIDE
Summary of Contents for Classic
Page 23: ......
