Please read the wind region and post hole depth charts carefully prior to starting
your installation.
We recommend you plan your wall set out/post position on a piece of paper first to save unnecessary
digging.
Accurately determine the boundary line to where the wall will be installed, (in some cases a surveyor may be
required) mark this with a string line as per the diagram below.
Note – the diagram on page 5 is for reference purposes only & shows the wall splitting the boundary line, this
may not always be the case depending on your individual circumstances.
Determine your posthole centres using the table as a guide and mark out your posthole positions on the
ground with line marking paint.
Note: Wall panels may be trimmed with a circular saw if necessary to fit in within an exact measurement
(panel cutting procedure is detailed on page 19.)
Postholes can be dug by hand or with a mechanical auger. Use the Footing Depth Table on page 5 to
determine your posthole depth and diameter.
Recommended footing depths listed here are for wind regions A & B plus terrain categories 2.0, 2.5 & 3. If
you are building your wall in a Cyclonic wind area, on the top of a hill, adjacent to an bank/cliff, on a ridge, or
in terrain category 1, you will need engineering advice beyond the scope of this publication.
5. External Panel
Capping
8. Capping Channel
End Post with End Post infill
Wall Panel & Joiner
12. Aluminium
Joiner
10. Wall Panel
50mm and 70mm
13. End Post Infill
1. Mid Post
9. Support Bracket
6. Exposed Post Top
2. 90˚ Post
7. Wall Mount Channel
& Masonry Anchor
3. 45˚ Post
4. Flush Post Top
4. End Post
4
/ SOLID PANEL INSTALLATION GUIDE
Summary of Contents for Classic
Page 23: ......
