
MEMORY ADDITION
To add memory to your BEL 6110 you will need to purchase extra memory modules
and an Eprom set.
To upgrade to 16m (84 secs stereo) you will require:-
1 off BEL 6110 memory module (8 Mbyte)
1 off BEL 6110 Eprom 16m - H
1 off BEL 6110 Eprom 16m - L
On CPU printed circuit board:-
Add memory module to Bank 1 and replace U22 with -H Eprom and U23 with -L
Eprom.
To upgrade to 32m (168 secs stereo) you will require:-
2 off or 3 off BEL 6110 memory modules (8 Mbyte) depending on existing memory
1 off BEL 6110 Eprom 32M - H
1 off BEL 6110 Eprom 32M - L
On CPU printed circuit board:-
Add memory modules to fill
ALL
banks (0-3) and replace U22 with -H Eprom and
U23 with -L Eprom.
To access CPU printed circuit board - remove power IEC connection and then
remove cover (19 off pozi type screws).
* see Printed Circuit Board layout drawing in service section.
POWER ON RESET
To reset the BEL 6110 to default settings proceed as follows:-
Power unit off
Power unit on and while the LCD display is showing the ÒLOGONÓ message Model/Version
etc, press the ÒSETÓ key and hold for approximately 3 seconds. A reset will now be initiated.
The display will acknowledge this by flashing the message Òpower-on resetÓ in the top left
corner of the LCD.
Default settings are:-
Digital Ref:
Audio in
Tracking mode - follow, 1 frame flywheel
Audio Mode - stereo
Audio Source - Analog
LTC editor stripping start 00:00:00:00
LTC editor video system - PAL
14
Summary of Contents for 6110
