8
EN
3
Installation
Appropriate installation location
Do not place it on a long pile rug or
similar surfaces.
and the dryer -with full load- when
they are placed on top of each other
Place the product on a solid and flat
floor that has sufficient load carrying
capacity!
power cable.
where temperature may fall below
from the edges of other furniture.
Removing packaging
reinforcement
After removing transportation locks
(see below) tilt the machine backwards
and remove the packaging reinforcement
attached to the ribbon.
Removing the
transportation locks
bolts before operating the washing
machine, otherwise, the product will
be damaged.
until they rotate freely (C).
turning them gently.
To make the product ready for use,
review the information in the user manual
and make sure that the electricity, tap water
supply and water drainage systems are
appropriate before installation. If they are
not ,call a qualified technician and
plumber to have any necessary
arrangements carried out.
Preparation of the location and
electrical, tap water and waste water
installations at the place of installation
is the customer's responsibility.
Installation and electrical connections
of the product must be carried out
Manufacturer shall not be held liable
for damages that may arise from
procedures carried out by unauthorised
persons.
by a competent person.
Prior to installation, visually check if
the product has any defects on it. If
so, do not have it installed. Damaged
products cause risks for your safety.
Make sure that the water inlet and
discharge hoses as well as the power
cable are not folded, pinched or
crushed while pushing the product into
its place after installation or cleaning
procedures.
Summary of Contents for WMC126W
Page 1: ...WMC126W ...
Page 5: ...WMC126W ...
Page 22: ...20 20 ...
Page 40: ...BEKO plc Beko House 1 Greenhill Crescent Watford Herts WD18 8QU ...