Beko WMC126W, Installation And Operating Instructions Manual

Page: 30 / 40

EN
a. Pull the emergency draining hose out
from its seat
b. Place a large container at the end
of the hose. Drain the water into
the container by pulling out the plug
at the end of the hose. When the
container is full, block the inlet of
UIFIPTFCZSFQMBDJOHUIFQMVH"GUFS
the container is emptied, repeat the
above procedure to drain the water in
the machine completely.
c. When draining of water is finished,
close the end by the plug again and
fix the hose in its place.
d. Turn the pump filter to take it out.
Discharging the water when the product
does not have an emergency draining
hose:
a. Place a large container in front of the
filter to catch water from the filter.
b. Loosen pump filter (anticlockwise)
until water starts to flow. Fill the
flowing water into the container
you have placed in front of the filter.
"MXBZTLFFQBQJFDFPGDMPUIIBOEZUP
absorb any spilled water.
c. When the water inside the machine is
finished, take out the filter completely
by turning it.
$MFBOBOZSFTJEVFTJOTJEFUIFGJMUFSBT
well as fibers, if any, around the pump
impeller region.
*OTUBMMUIFGJMUFS
A
*GZPVSQSPEVDUIBTBXBUFSKFUGFBUVSF
be sure to fit the filter into its housing
in the pump. Never force the filter
while installing it into its housing. Seat
the filter into its place completely.
Otherwise, water may leak from the
filter cap.
*GUIFGJMUFSDBQJTDPNQPTFEPGUXP
pieces, close the filter cap by pressing
on the tab. If it is one piece, seat the
tabs in the lower part into their places
first, and then press the upper part to
close.