Beko WDIX8543100, User Manual

Page: 65 / 84

User’s Manual
65 / EN
Troubleshooting
• Draining hose is not at adequate height. >>>
Connect the water draining hose as
described in the user manual.
No water can be seen in the machine during washing.
• The water level is not visible from outside of the washing machine. This is not a
failure.
Loading door cannot be opened.
• Loading door lock is activated because of the water level in the machine. >>>
Drain the water by running the Pump or Spin programme.
• Machine is heating up the water or it is at the spinning cycle. >>>
Wait until the
programme completes.
• Loading door lock is engaged. Loading door lock will be deactivated a couple of
minutes after the programme comes to an end. >>>
Wait for a couple of minutes for
deactivation of the loading door lock.
Washing takes longer than specified in the user manual.(*)
• Water pressure is low. >>>
Machine waits until taking in adequate amount of water
to prevent poor washing quality due to the decreased amount of water. Therefore, the
washing time extends.
• Voltage is low. >>>
Washing time is prolonged to avoid poor washing results when the
supply voltage is low.
• Input temperature of water is low. >>>
Required time to heat up the water extends
in cold seasons. Also, washing time can be lengthened to avoid poor washing results.
• Number of rinses and/or amount of rinse water have increased. >>>
Machine
increases the amount of rinse water when good rinsing is needed and adds an extra
rinsing step if necessary.
• Excessive foam has occurred and automatic foam absorption system has been
activated due to too much detergent usage. >>>
Use recommended amount of
detergent.
Programme time does not countdown. (On models with display) (*)
• Timer may stop during water intake. >>>
Timer indicator will not countdown until
the machine takes in adequate amount of water. The machine will wait until there is
sufficient amount of water to avoid poor washing results due to lack of water. Timer
indicator will resume countdown after this.
• Timer may stop during heating step. >>>
Timer indicator will not countdown until
the machine reaches the selected temperature.
• Timer may stop during spinning step. >>>
Automatic unbalanced load detection
system might be activated due to the unbalanced distribution of the laundry in the drum.
Programme time does not countdown. (*)
• Laundry is unbalanced in the machine. >>>
Automatic unbalanced load detection
system might be activated due to the unbalanced distribution of the laundry in the drum.
Machine does not switch to spinning step. (*)