Beko WDIX8543100, User Manual

Page: 20 / 84

20 / EN
Washer-Dryer
Installation
3.3 Removing the transit bolts
A
PRECAUTION
• Do not remove the transit bolts before removing the
packaging reinforcement.
• Remove the transit bolts before operating the washing
machine! Otherwise, the product will get damaged.
3
2
1
1 Use a tool to loosen all bolts until they rotate freely. (C)
2 Remove the transit bolts by turning them slightly.
3 Attach the plastic covers supplied in the user manual bag into the holes on the rear
panel. (P)
C
INFORMATION
• Keep the transit bolts in a safe place to reuse when the
product needs to be moved again in the future.
• Never move the product without the transit bolts properly
fixed in place!
3.4 Connecting water supply
C
INFORMATION
• The water supply pressure required to run the product is
between 1 to 10 bars (0.1 – 1 MPa). It is necessary to have
10 – 80 liters of water flowing from the fully open tap in
one minute to have your product run smoothly. Attach a
pressure reducing valve if water pressure is higher.
A
CAUTION
• Models with a single water inlet should not be
connected to the hot water tap. In such a case the
laundry will get damaged or the product will switch to
protection mode and will not operate.
• Do not use old or used water inlet hoses on the new
product. It may cause stains on your laundry.