83 / EN
Washer-Dryer / User Manual
After every washing and
drying make sure that
no foreign substance is
left in the drum.
If the holes on the
bellow shown in the
figure are blocked,
open the holes using a
toothpick.
C
INFORMATION
• Foreign metal substances will cause rust
stains in the drum. Clean the stains on the
drum surface by using cleaning agents for
stainless steel. Never use steel wool or wire
wool.
A
CAUTION!
• Never use sponge or scrub materials.
These will damage the painted, chrome
and plastic surfaces.
6.3 Cleaning the body
and control panel
Wipe the body of the machine with soapy
water or non-corrosive mild gel detergents as
necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the
control panel.
6.4 Cleaning the water
intake filters
There is a filter at the end of each water intake
valve at the rear of the machine and also at
the end of each water intake hose where they
are connected to the tap. These filters prevent
foreign substances and dirt in the water to enter
the washing machine. Filters should be cleaned
if they are dirty.
6 Maintenance and cleaning
Service life of product extends and frequently
experienced problems will be reduced if it is
cleaned at regular intervals.
6.1 Cleaning the detergent drawer
Clean the detergent
drawer at regular
intervals (every 4-5
washing cycles)
as shown below
in order to prevent
accumulation of
powder detergent in
time.
1 Remove the siphon by lifting it from behind
as shown in the picture. After performing
the below mentioned cleaning procedures,
replace the siphon back to its seating
and push its front section downwards to
make sure that the locking tab engages.
C
INFORMATION
• If more than normal amount of water and
softener mixture remains in the softener
compartment, the siphon must be cleaned.
2. Wash the detergent drawer and the siphon
with plenty of lukewarm water in a washbasin.
In order to prevent the residues to contact
your skin, clean it with an appropriate
brush by wearing a pair of gloves.
3 Insert the drawer back into its place after
cleaning and make sure that it is seated well.
6.2 Cleaning the loading
door and the drum
For products with drum cleaning programme,
please see Operating the product - Programmes.
C
INFORMATION
• Repeat Drum Cleaning process in every 2
months.
• Use an detergent /anti-limescale suitable
for the washing machines.
