Page 18
Once cooking has finished, the user
interface indicates if there is remaining heat
in the corresponding heater.
Remaining heat will be indicated only when
the heater temperature goes beyond 65ºC
(149ºF). To ensure that a heater reaches a
temperature greater than this, it is necessary
that the heater is working for more than 7
seconds in a power level greater than zero.
As radiant heaters temperatures are not read
directly, it is necessary to estimate the time
that the heater will be hot after cooking.
During this time, shown in table 1, letter ‘H’
will be show alternatively with ‘0’, indicating
hot remaining.
Residual Heat
Radiant Heaters Residual Heat
Automatic actions
Protection from accidental activation of
keys
If any key/s is continually pressed for more
than 10 seconds, the cooktop is switched off
automatically. A warning beep sounds every
10 sec., while the key/s is/are activated.
Heater auto switch off in a specific time
After the maximum time of operation at the
same power level, the heater is switched off
automatically.
The heater auto switch off time is
automatically reset when the power level is
changed.
Thermal protection of the control.
When the control user interface detects an
ambient temperature above 96°C(+-5%), it
switches off the cooktop. Any heater
switched off by the thermal protection can
only be reactivated when the temperature
falls below 89°C(+-5%).
When the heater power control detects an
unusually high operating temperature for its
devices, it switches off all the heaters until
the temperature reaches normal operating
values, thereafter continuing with their
previous power level values.
The Stop and Go function allows temporary
pausing of the cooking process, allowing the
user to answer the door or the telephone
without having to be concerned about
contents of pots boiling over.
This function is also useful to clean the user
interface surface without changing the
cooking set up.
If the [STOP_GO_KEY] is pressed for more
than 120 milliseconds:
x
The
[STOP_GO_LED]
flashes,
a
[STOP&GO_SOUND] sounds and the
cooktop is stopped,
x
the heaters actual power setting is stored
and all the active heaters power is set to
power level 0,
x
the heaters auto switch off time is
stopped,
x
all timers running count downs are
stopped,
x
all
keys
are
locked
except
[STOP_GO_KEY] and [ON_OFF_KEY],
x
timer displays nothing, and all the heaters
displays are switched on and display “0”.
Stop & Go function
