Installation
Permissible water temperature:
up to 25°C
It is not recommended to connect
the dishwasher to open water
heaters or continuous flow water
heaters.
•
Do not use an old or used water
inlet hose on your new product. Use
the new water inlet hose supplied
with the product.
•
Connect the water inlet hose directly
to the water tap. The pressure
coming from the valve must be at
least 0.3 and at most 10 bars. If the
water pressure is higher than 10
bar, a pressure reducer must be
fitted between the two.
•
Fully open the taps after making
the connections to check for water
leaks.
connection must be at least 50 cm and at
most 100 cm from the ground. A drain
hose longer than 4 meters may cause
faulty washing.
Attach the water drain hose to the
drain hose without bending it.
Secure the drain hose to the drain
hose tightly to prevent the drain
hose from moving during product
operation.
VS
Use a hose connector wrench
to connect the water inlet hose
to the water faucet with a 3/4
foot outside wire. If necessary,
use a filter to filter the residue
from the pipes.
VS
The drain hose must be
connected to the sewer and
must not be connected to
surface water.
Leg adjustment
If the product door cannot be closed
tightly or the product rocks when you
push it lightly, you need to adjust its
feet. Adjust the feet of the product as
shown in the installation manual
supplied with the product.
AT
For your safety, completely
close the water inlet tap
after the end of the washing
programme.
AT
The dishwasher door must
be properly aligned to
prevent hot steam from
escaping! Risk of severe
burns, other types of
injury or damage to
furniture.
Connecting the drain pipe The water
drain pipe can be connected directly
to the drain pipe or to the sink drain.
The length of this
10 /44 EN
Dishwasher / Instructions for use
max
1000
mins
5 00
min 120
min 300
