Dryer / User Manual
11 / 28 EN
3
Installation
Before the calling the nearest Authorized Service for the
installation of the dryer, ensure that electrical installation
and water drain is appropriate referring to the user's
manual.
(See 3.3 Connecting to the drain
and
3.5
Electrical connection)
If they are not suitable, contact
a qualified electrician and technician to make necessary
arrangements.
C
Preparation of the dryer's location
as well as the electrical and waste
water installations is under customer's
responsibility.
A
Prior to installation, visually check if the
dryer has any defects on it. If the drier
is damaged, do not have it installed.
Damaged products cause risks for your
safety.
3.1 Appropriate installation location
Install the dryer on a stable and level surface.
Dryer is heavy. Do not move it by yourself.
•
Operate your dryer in a well ventilated, dust-free
environment.
•
The gap between the dryer and the surface should
not be reduced by the materials such as carpet,
wood and tape.
•
Do not cover the ventilation grills of the dryer.
•
There must not be a lockable, sliding or hinged door
that may block the opening of the loading door in
the place where your dryer is to be installed.
•
Once the dryer is installed, it should stay at the
same place where its connections have been made.
When installing the dryer, make sure that its rear
wall does not touch anywhere (tap, socket, etc.).
•
Place the dryer at least 1 cm away from the edges
of other furniture.
•
Your dryer can be operated at temperatures
b5°C and +35°C. If the operating
conditions fall outside of this range, operation of
the dryer will be adversely affected and it can get
damaged.
•
The rear surface of the tumble dryer shall be placed
against a wall.
B
Do not place the dryer
on the power
cable.
3.2 Removing the transportation safety
assembly
A
Remove the transportation safety
assembly before using the dryer for the
first time.
Open the loading door.
There is a nylon bag inside the drum that contains a piece
of styrofoam. Hold it from its section marked with
XX XX
.
Pull the nylon towards yourself and remove the transporta-
tion safety assembly.
A
Check that no part of the transportation
safety assembly remains inside the drum.
3.3 Connecting to the drain
In products equipped with condenser unit, water accumu-
lates in the water tank during the drying cycle. You should
drain accumulated water after each drying cycle.
You can directly drain accumulated water through the wa-
ter drain hose supplied with the product instead of periodi-
cally draining the water collected in the water tank.
Connecting the water drain hose
1-2
Pull hose at the behind of the dryer by hand in order
to disconnect it from where it is connected. Do not
use any tools to remove the hose.
3
Connect one end of the drain hose supplied with
the dryer to the connection point from where you
removed the hose of the product in previous step.
4
Connect the other end of the drain hose directly to
the wastewater drain or to the washbasin.
Summary of Contents for DCY 8502 XB1
Page 1: ...DCY 8502 XB1 Dryer User Manual 2960310884_KM 070514 0837 ...
Page 27: ...Dryer User Manual ...
Page 28: ......
