Beko BEHPH 090, User Manual

Page: 33 / 228

33 / 172 EN
Split Type Air Conditioner / User Manual
C
While crimping wires, make sure
you clearly distinguish the Live
(“L”) Wire from other wires.
A
WARNING!
All wiring work
must be performed strictly in
accordance with the wiring
diagram located inside of wire
cover of the outdoor unit.
2. Unscrew the electrical wiring cover and remove
it.
3. Unscrew the cable clamp below the terminal
block and place it to the side.
4. Connect the wire according to the wiring
diagram, and firmly screw the u-lug of each
wire to its corresponding terminal.
5. After checking to make sure every connection
is secure, loop the wires around to prevent rain
water from flowing into the terminal.
6. Using the cable clamp, fasten the cable to the
unit. Screw the cable clamp down tightly.
7. Insulate unused wires with PVC electrical tape.
Arrange them so that they do not touch any
electrical or metal parts.
8. Replace the wire cover on the side of the unit,
and screw it in place.
Cover
Screw
Cover
Screw
C If the cable clamp looks like
the following, please select
the appropriate through-hole
according to the diameter of the
wire.
Three size hole: Small, Large, Medium
When the calbe is not fasten enough, use the
buckle to prop it up , so it can be clamped tightly.
Buckle
When the calbe is not fasten enough, use the buckle
to prop it up, so it can be clamped tightly.
Buckle
Three size hole: Small, Large, Medium
In North America
1. Remove the wire cover from the unit by
loosening the 3 screws.
2. Dismount caps on the conduit panel.
3. Temperarily mount the conduit tubes (not
included) on the conduit panel.
4. Properly connect both the power supply and low
voltage lines to the corresponding terminals on
the terminal block.
5. Ground the unit in accordance with local codes.
6. Be sure to size each wire allowing several inches
longer than the required length for wiring.
7. Use lock nuts to secure the conduit tubes.
4 Installation