BEKA ONE 120, Assembly And Operating Instrustions

Page: 27 / 76

-26-
07 - Adjustment
Switching off and changing the setting
The activation cap is the key component of the BEKAONE120 . Use the activation cap to set important
functions such as power on and off or adjusting the operation time.
Place the activation cap on the red point and wait until the red
LED has flashed
5 times . Then remove the cap.
The pump is turned off. The red LED glows for 5 seconds. Now,
you can switch the pump on again and change a setting resp.
reselect it as described in steps 1-3 above.
Switching on and adjusting the operation time
Remove the activation cap
and guide it to the red point
above the activation zone. Place the cap on the red point and wait until the red LED has flashed
5 times . Remove the cap for 1-2 s and then place it immediately
back on the red point.
The green LEDs are now flashing in a line. Remove the activation cap when the required month setting is
flashing (for example, 12). The pump is adjusted and starts lubricating after a short time.
1.
2.
3.
Example: selected setting 12 months
6
4
5
3
2
1
< s 1-2
EN