Page
8 ©
BEKA 2015 All rights reserved!
...a product of
7.
Start up
7.1
Setting the delivery rate
The delivery rate can be set progressively via the setscrew (6, Fig.2)
for the delivery rate within a range from 0,2 to 2,0 cm³/stroke.
Normally the delivery rate is preadjusted to 2,0 cm³/stroke. Dimension
Y determines the flow rate of the device (see Fig.3).
Release lock nut (7, Fig.2)
Set delivery rate via the setscrew (6, Fig.2)
-
Turn clockwise to reduce the delivery rate; turn counter-
clockwise to increase it.
-
One turn of the setscrew corresponds to 1 mm and approx.
0,2 cm³/stroke
Retighten lock nut.
7.2
Replacement of grease cartridge
The device is filled with commercially available grease cartridges of type S.
Observe utmost cleanness when changing the grease cartridge!
Unscrew grease cartridge (20, Fig.2) counter-clockwise out of the pump housing (1, Fig.2).
Dispose empty grease cartridge properly.
Screw in the new cartridge clockwise into the pump housing.
Air may have entered into the system through the grease cartridge replacement. The grease area must be bled after each
grease cartridge replacement.
7.3
Ventilation (grease area)
Ventilate the complete system after the start-up as well as after a grease cartridge exchange.
Ventilation is done by operating the system in pressureless condition and with open system outlets. Remove the pressure line
from the set screw (6, fig. 2).
Operate the device until lubricant comes out of the pressure connection without air inclusions!
7.4
Ventilation (oil area)
Ventilate the oil section of the device after each first- or reconnection of the hydraulic connection.
Release ventilation screw (9, Fig.2) (it is not necessary to turn it out completely).
Fill oil area until oil escapes through the ventilation screw.
Retighten ventilation screw.
Stroke
setting „Y
“ in mm
Delivery rate in cm³/stroke
Fig.3
