BEKA BA364E, Manual

Page: 2 / 60

1. Description
2. Operation
2.1 Initialisation
2.2 Controls
2.3 Displays
3. Intrinsic Safety Certification
3.1 ATEX gas certification
3.2 Zones, gas groups & T rating
3.3 Special conditions for safe use
3.4 Power supply
3.5 Pulse input terminals
3.5.1
Sensors that do not require
energising.
3.5.2 Sensors that do require
energising.
3.6 Remote reset terminals
3.7 Certification label information
4. System Design for Hazardous Areas
4.1 Use with Zener barriers
4.1.1
Power supply
4.1.2 Pulse input
4.1.3 Switch contact input
4.1.4 2-wire proximity detector input
4.1.5 Open collector
4.1.6 Magnetic pick-off input
4.1.7 Voltage pulse input
4.1.8 Remote reset
4.2 Use with galvanic isolators
4.2.1
Power supply
4.2.2 Pulse input
4.2.3 Switch contact input
4.2.4 2-wire proximity detector input
4.2.5 Open collector
4.2.6 Magnetic pick-off input
4.2.7 Voltage pulse input
4.2.8 Remote reset
5. Installation
5.1 Location
5.2 Installation procedure
5.3 EMC
5.4 Units of measurement and tag marking
on scale card.
6. Configuration and Calibration
6.1 Calibration structure
6.2 Accessing configuration functions
6.3 Summary of configuration functions
6.4 Input A:
inPut-A
6.5 Input A type:
inP. tYPE
6.6 Input A debounce:
dEbouncE
6.7 Input b:
inPut-b
6.8 Input b type:
inP. tYPE
6.9 Input b debounce:
dEbouncE
6.10 Input A pulse counting edge:
CntEdg-A
6.11 Input b pulse counting edge:
CntEdg-b
6.12 Display update interval:
uPdAtE
6.13 Counting function:
Count
6.14 Upper display:
di5P-1
6.15 Lower display:
di5P-2
6.16 Position of the decimal points:
dP
6.17 Total scale factor:
5CALE . t
6.18 Rate scale factor:
5CALE . r
6.19 Timebase:
t-bA5E
6.20 Display filter:
FiLtEr
6.21 Direction of count:
uP or dn
6.22 Reset value:
CLr VAL
6.23 Local reset:
LoC CLr
6.24 Local total reset:
Clr tot
6.25 Local grand total reset:
Clr Gtot
6.26 Reset grand total from configuration
menu:
Clr Gtot
6.27 Security code:
CodE
6.28 Reset configuration to factory defaults:
r5Et dEF
6.29 Display overflow
7. Pulse Output
7.1 Intrinsic safety
7.2 System design
7.3 Configuration
7.4 Access Pulse output sub-menu:
PuL5E oP
7.5 Enable pulse output:
EnbL
7.6 Source of output pulse:
5ourCE
7.7 Divide output pulse frequency:
diVidE
7.8 Output pulse width:
durAtion
8. Configuration example
2222222222222222222222222
CONTENTS
The BA364G and BA364E are CE marked to show compliance with the European Explosive Atmospheres
Directive 2014/34/EU and the European EMC Directive 2014/30/EU