1. Description
2. Operation
2.1 Controls
2.2 Displays
3. Intrinsic Safety Certification
3.1 ATEX gas certificate
3.2 Zones, gas groups & T rating
3.3 Special conditions for safe use
3.4 4/20mA input
3.5 Reset terminals
3.6 Certification label information
4. System Design for Hazardous Areas
4.1 Flow transmitter loops
4.2 Resetting the total display to zero
4.3 Remote indication
5. Installation
5.1 Location
5.2 EMC
5.3 Installation procedure
5.4 Scale card
6. Configuration and Calibration
6.1 Calibration structure
6.2 Accessing configuration & calibration
functions.
6.3 Summary of configuration
functions.
6.4 Rate totaliser function
6.5 Display resolution
6.6 Display update time
6.7 Upper display
6.8 Lower display
6.9 Position of decimal points
6.10 Calibration of rate display using an
external current source.
6.11 Calibration of rate display using internal
reference.
6.12 Clear grand total
6.13 Timebase
6.14 Function of
P
push button
6.15 Total scale factor
6.16 Clip off
6.17 Local reset of total and grand total
displays.
6.18 Security code
6.19 Reset to factory defaults
6.20 Over-range
7. Lineariser
7.1 Calibration using external current
source.
7.1.1
Example, Adding break-points
to a new Rate Totaliser
7.2 Calibration using internal reference
7.2.1
Example, Adding break-points
to a new Rate Totaliser
7.3 Error messages
7.4 Under and over-range
7.5 Default configuration
8. Calibration Examples
8.1 Using an external current source
8.2 Using the internal reference
9. Maintenance
9.1 Fault finding during commissioning
9.2 Fault finding after commissioning
9.3 Servicing
9.4 Routine maintenance
9.5 Guarantee
9.6 Customer comments
10. Accessories
10.1 Scale card
10.2 Tag information
10.3 Alarms
10.3.1 Solid state output
10.3.2 Intrinsic safety
10.3.3 Configuration and adjustment
10.3.4 Alarm enable
10.3.5 Type of alarm
10.3.6 Setpoint adjustment
10.3.7 Alarm function
10.3.8 Alarm output status
10.3.9 Hysteresis
10.3.10 Alarm delay
10.3.11 Alarm silence time
10.3.12 Flash display
10.3.13 Access setpoint
10.3.14 Adjusting alarm setpoints
from display mode.
10.4 Display backlight
10.4.1 Loop powered
10.4.2 Separately powered
Appendix 1
ATEX dust certification
Appendix 2
IECEx certification
Appendix 2
FM and cFM certification
22
The BA358E is CE marked to show compliance with the European Explosive Atmospheres Directive
94/9/EC and the European EMC Directive 2004/108/EC
CONTENTS
