Changing The Hydraulic Oil
Pouring Out The Hydraulic Oil
ü
Lower down until it receives the cutting head.
ü
Remove hydraulic hose union at head lifting
ü
Put the removed hydraulic end of the hose into a container.
ü
Empty the oil by pressing head lifting button at control panel.
After empting the oil, fix the hydraulic hose union to the same place.
Refilling the hydraulic oil
The hydraulic oil filling
ü
Remote the bolts of hydraulic drawer, then pull it out.
ü
Open the store cover.
ü
Pour 46 numbered iso hydraulic oil into tank. (8lt capacity.)
ü
Close the tank cover and move the drawer into the body
Fasten the screws to the body again with the help of hydraulic drawer.
Filling Of Coolant
Consisting of a mixture of liquid and water coolant liquid should be used for steel cutting. Coolant should not be used for cutting casting. Specific periods of time (at least once a month)
, coolant should be drained and clean chips. İf amount of coolant is not enough, add to the tank. (4 liters of tank capacity. Collant mixing ratio 1/10)
Setting New Blade
·
First of all both guard flaps and the guards which are on the guide arms have to be open upwards.
·
Loosen the blade by the hand level so far that the blade can be easily taken off around the pulleys
·
The same way but vic averse, fit and tighten the new blade. There is also possibility to tighten the blade by torque meter.
·
Always pay attention to the teeth of the blade’s direction is correct. İf not correct it.
Cutting Speeds
The machine has two pre-selected cutting speeds of 20 and 100 m/sec. Cutting speeds has to be selected according to the grade and dimensions of the m aterial. İf any vibration and/or
noise raises from the blade, change the speed.
·
All the details about the cutting of various materials and dimensions are given below