Beka Hospitec 921077000, Original Manual

Page: 14 / 60

Installation
Operating manual NORA Pro V0.1 E Page 14 of 60
6 Installation
The product is supplied ready for use.
6.1 Electrical connection
Before you start using our products, your electrical installation must be checked in
accordance with the relevant VDE-regulations 0100 and 0100-710. This requirement is
only applicable in Germany. In other countries, other requirements might be applicable.
Ask a qualified electrician to install the charging unit in accordance with the regulations
applicable in your country. The socket must meet the requirements of VDE 0100 and
0100-710.
6.2 First start-up
WARNING
The equipment is to be used exclusively in accordance with the
accompanying documents.
Only when these conditions are met, the manufacturer considers
himself responsible for the impact on the safety, the reliability and the
function of the device.
In the event of a newly connected product, the technical data must
be observed.
HINWEIS
The battery must be completely charged prior to the first use
(initial charging time min. 12 hours).
Please check that the emergency stop switch is released prior
to moving the spreader bar.
The NORA Pro sit-to-stand lift is equipped with an electrical motor. This motor is self-
locking and therefore protected against unintentional lowering of the spreader bar in
case of malfunction or failure. The battery of the NORA must be completely charged
before starting to use the device.
Please check that the emergency stop switch is released (unlatched). To unlatch, turn
the button of the emergency stop switch clockwise (i.e., to the right) until it releases.