Page 5
Display legend
Displays the type of probe or device
Displays the serial number
Displays the week and year of manufacture
Displays tth e remaini ng days a t th e end of the
operating cycle.
Displays how many times the probe has been turned
o n .
Displays how many times is gone into alarm.
Displays how many corrections have been done
Displays the operating range if at 20 or at 100% of LEL
Displays a scrolling to the normalized value, coming
out of the gas cap, modifying these data compromises
th e f u n cti o n i n g a n d i s reserved f o r a u th o ri zed
technicians.
Operation of the TS1008 Tester
By connecting the TS1008 tester, you can proceed to check the probe in question and print the test report.
ADC 80 16 (125 145)
probe sg-O
2
100
sn 24ad12
date 15 2014
DaY 2190
cy 5
al 15
drift 12
range 20
lel 20% (fault)
print
tar
new save
low bat
Edit
Enter
TS1008
Se ns or
Analy ze r
*
%
2
UP Down
L EL 2 0
Connections Tester TS1008
Attention!!
The regulations described in this paragraph must performed be authorized and specialized
technician are suceptibile to compromise the safety of the survey.
If the device does not start up.
Check that the 12/24 Vdc power is present, and that positive and negative polarity has not been inverted.
If the Fault LED lights up.
Check that the cables are connected according to the drawing, and that the wire isolation sheath has not been
pinched.
Check the voltage at the terminals 1-2. It must be higher than 10,80 Vdc and lesser than 26,4 Vdc.
Check that the connector of the sensor is correctly inserted.
If it’s connected to control unit. Check the voltage at the terminals 2-3. It must be from a minimum of
0.8 Vdc to a maximum of 1.1 Vdc.
Remark
.
If the probes are connected to the control units BX308 and BX316 the voltage at the terminals 2 and 3 must
be from a minimum of 0.6 to a maximum of 0.75 VDC
If othe r p rob le ms arise , a sp e cialise d and /or authorise d te chnician and /or the Distrib utor of
BEINAT S.r.l. should be contacted directly.
WARNING.
These measurement should be performed in
clean air.
Moreover, this test must be performed only
with the probe connected to a control unit, or
with a 220 Ohm resistance installed between
terminal 2 and terminal 3.
.
Troubleshooting before calling a technician
Linear Otput 4-20 mA
3 2 1
R
0
1
3
2
1,1
V.
Vol tmeter
Power Supply
12÷24 V.
