PCI1040 Motion Control Card
Chapter 2 Component Layout and Pin Layout
2.1 Component Layout
2.1.1
Signal Input and Output Connectors
CN1: analog signal input and output connectors
2.2.2
Status Indicator
+5V: 5V power supply indicator, on for normal
2.2.3 Physical ID of DIP Switch
DID1: Set physical ID number. When the PC is installed more than one PCI1040 , you can use the DIP switch to
set a physical ID number for each board, which makes it very convenient for users to distinguish and visit each
board in the progress of the hardware configuration and software programming. The following four-place
numbers are expressed by the binary system: When DIP switch points to "ON", that means "1", and when it
points to the other side, that means "0." As they are shown in the following diagrams: place "ID3" is the high
bit."ID0" is the low bit, and the black part in the diagram represents the location of the switch. (Test software of
the company often uses the logic ID management equipments and at this moment the physical ID DIP switch is
BUY ONLINE at art-control.com/englishs or CALL +86-(0)10-51289836(CN)
5
