Beijer Electronics X-Key 16, Manual, Page: 11 / 50

Setup
Beijer Electronics, MAEN827B 11
Special functions in X-Key 16 can be performed by using the key combinations
in the table below.
Function keys Function
F16 + F1 Sets the station number to 1. Default setting.
F16 + F2 Sets the station number to 2.
F16 + F3 Sets the station number to 3.
F16 + F4 Sets the station number to 4.
F16 + F9 Sets the baud rate to 9,600.
F16 + F10 Sets the baud rate to 19,200.
F16 + F11 Sets the baud rate to 38,400. Default setting.
F16 + F13 Sets RS422 as the communication port used.
F16 + F14 Sets RS232C as the communication port used. Default setting.
F16 + F15 Sets RS485 as the communication port used.
F16 + F7 Enables the X-Key 16 connected to the operator terminal to pass
through messages to other stations in the RS485 network.
F16 + F8 Clears F16 + F7 , and disables pass through. Default setting.
F1 + F2 Prepares for loading of system program.*
F1 + F9 Start of self test.*
* Functions intended for troubleshooting and updating, normally not used.
Note:
If only one X-Key 16 is used, pass through must not be enabled (the LED L7 must
not light up in green when the power is turned on).