18
Dis play
M ode
0
No c ontroller data are trans m itted
1
Controller data are rec eived but not trans m itted
2
Controller data are trans m itted but not rec eived
3
Controller data are trans m itted and rec eived
Tab. 2.1: Controller settings
The fourth page gives you access to the program change setup. The display shows a capital P (=Program).
Here, too, four modes can be selected with the jog wheel, as follows:
Display
Mode
0
Program changes are not transmitted
1
Program changes are received but not transmitted
2
Program changes are transmitted but not received
3
Program changes are transmitted and received
Tab. 2.2: Program change settings
The fifth page of the MIDI menu shows the store enable flag represented by a capital S in the display. The
value 0 disables the reception of controller #28, and therefore protects the user presets from being modified
via MIDI. Accordingly, the value 1 enables MIDI controller #28 so that you can modify or replace presets with
a remote MIDI device or a sequencer. In this case the actual settings will be stored directly to the location that
corresponds to the controller value.
+
Attention! Since the store enable mode allows you to access memory locations directly via
MIDI, it is possible that stored presets will be replaced or altered if controller #28 messages are
sent on the same MIDI channel. The purpose of this mode is to facilitate MIDI backup and
restore operations without express confirmation at the VIRTUALIZER PRO. It is therefore rec-
ommended to disable (flag=0) this mode as soon as the intended data transfer has ended. This
is done automatically when you switch off the VIRTUALIZER PRO.
If you press the IN/OUT key again on the fifth page, the VIRTUALIZER PRO quits MIDI setup mode.
On the sixth and last page, you can access the System Exclusive functions. This is indicated by a d (for
dump) in the display. To the left of this d a number is displayed:
- 0 means that no SYSEX data will be sent or accepted.
- 1 will enable the VIRTUALIZER PRO to receive data. When STORE is pressed the unit will wait for data, this
is shown by flashing dots (LEDs) in the display. The MIDI key LED flashes signaling that SYSEX data is
being received.
- 2 will enable the VIRTUALIZER PRO to send a bulk dump. Start your sequencer and press STORE on the
DSP1000P to start the transmission.
To load these settings again, select 1, press STORE and start your sequencer. If you press IN/OUT again,
you will leave the MIDI setup. At all times you can press any other key to leave the MIDI setup directly.
+
During a bulk dump, all audio functions of the VIRTUALIZER PRO will be deactivated.
The full-featured MIDI implementation of the VIRTUALIZER PRO allows for easily integrating of the
VIRTUALIZER PRO into any MIDI system.
s
MIDI IN
Any MIDI data sent to the VIRTUALIZER PRO (sequencer, MIDI footswitch, etc.) is received via the MIDI IN
jack. For example, when you wish to use the VIRTUALIZER PRO as an effects devices for your guitar rack,
you can connect the MIDI IN jack to a MIDI footswitch that allows for selecting program presets. If your rack
includes another MIDI effects devices (e.g. a multi-effects processor), the data sent from the MIDI footswitch
can be routed via the VIRTUALIZER PROs MIDI THRU jack to your multi-effects processor.
2. OPERATION
Get user manuals:
