ENGLISH
OPERATION
MANUAL
JB SYSTEMS®
7/41
LED BALL
D. Controlled by universal DMX-controller:
•
Connect all units together. Refer to the chapter “Electrical installation for two or more units in DMX-
mode” to learn how to do this (don’t forget to address all units properly!)
•
Connect all units to the mains and turn on the DMX controller.
Since each unit has its own DMX-address, you can control them individually. Remember that each unit
uses 4 DMX-channels as shown in the DMX chart below:
MAINTENANCE
•
Make sure the area below the installation place is free from unwanted persons during servicing.
•
Switch off the unit and unplug the mains cable.
During inspection the following points should be checked:
•
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
•
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
•
When an optical part is visibly damaged due to cracks or deep scratches, it must be replaced.
•
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
•
The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
•
The cleaning of internal and external optics must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly
dirty surroundings can cause greater accumulation of dirt on the unit’s optics.
•
Clean with a soft cloth using normal glass cleaning products.
•
Always dry the parts carefully.
•
Clean the external optics at least once every 30 days.
•
Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
ENGLISH
OPERATION
MANUAL
JB SYSTEMS®
8/41
LED BALL
SPECIFICATIONS
Mains Input:
AC 100V~240V 50/60Hz
Fuse:
250V 2A slow blow (20mm glass)
Sound Control:
Internal microphone
DMX connections:
3 contacts numbered 1,2,3 for DMX in/output
LEDs:
91 high power LEDs (R31 + G30 + B30)
Size:
see drawing below
Weight:
1,5kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
