Memory of alarm
When the system detected an attempted burglary, the deactivation of the system (press button ), the siren will beep four times (instead
of 2 times) and turn signals will flash four times (instead of 2 times)
Detection of attempting to start engine
When the system is activated, if an attempt to establish contact with the two wheels is performed, the siren sounds and flashing lights
for 30 seconds (3 cycles of 30 sec.). The screen on the remote LCD shows the icons as shown against (8)
Automatic reactivation
When the system is activated, press the button to disable it. If you do not touch the two front wheels 60 seconds, the system will
activate again
Nonvolatile memory
If you disconnect the battery from the two wheels, the system will remain in the selected state and retain its settings without resetting the battery reconnection.
Programming a new remote
If you have lost a remote, you can delete the remote memory system. This procedure helps to reprogram a new remote. Please follow this procedure:
1. Turn off the system
6. Press the button on the remote control to program
2. Before 5 sec., Press the button 3 times
7. The siren will beep once to confirm programming
3. The siren will beep once
8. Press the button other remotes* to program if necessary
4. Press the push button 5 times
9. The siren beeps at each new programming
5. You enter the programming mode
10. 10 sec. later, the siren will beep 3 times to indicate the mode output
* A maximum of 2 remote you can program two-way LCD remote and 4 simple uni-directional
11
(8)
