Remote Start (5)
When the alarm is activated, press the for 3 seconds, the system will remote start on 2 wheels. The siren beeps 3 times. Two wheels
of the engine starts, to confirm the correct engine start, the siren sounds 3 beeps again. The remote is flashing icon engine 4 times to
indicate that the motor turns the wheels 2. The screen on the remote LCD shows the icons as shown against (5). The remote control will
be illuminated in red to indicate the engine is running.
After remote start, the engine continues to run for 8 min. then shuts off and the system returns to normal activated alarm.
If you want to stop the engine during this phase of 8 min., Press the , siren and remote bipent 2 times and the remote beeps two
times. The motor stops.
On failure of remote start, possible causes are:
. the battery is too low, you need to replace or recharge your battery,
. the engine is cold and requires activation of the starter for power-up.
Impact detection sensor by SHOCKLIFT ™ (6)
If the system detects a collision, the siren will beep 5 times, turn signals will flash 5 times, the remote beeps for 15 seconds. The remote
vibrates 4 times to recall the shock to the owner of two wheels., The remote screen turns red.
If another shock is detected within 30 seconds, the siren sounded for 30 seconds, turn signals flashing for 30 seconds, the remote beeps
for 15 seconds. The screen on the remote LCD shows the icons as shown against (6)
Inclination detection / Sensor heave SHOCKLIFT ™ (7)
If the system detects an inclination or an uprising, the siren will beep 12 times, turn signals will flash 5 times, the remote beeps for 15
seconds and the display shows
333
. The remote vibrates 4 times to remind the owner of detection 2 wheels., The remote screen turns
red.
If a strong or fast inlcinaison is detected, the siren sounded for 30 sec., Turn signals flashing for 30 seconds, the remote beeps for 15
seconds and the display shows
333
.. The screen on the remote LCD shows the icons as shown against (7)
10
(5)
(6)
(7)
