• Do not connect the wire by splicing / soldering without using lugs. The connections may create serious problems with the system and
the vehicle also.
• When you connect the general ground of the system, it is very important that this ground is completely open and stable (no leakage).
• Ensure that every son passing in tight spaces are protected by adhesive tape to avoid excessive twisting and degradation of the plastic
wire with a risk of bad contacts.
• Please ensure that the wire of the system and all safety devices are best possible hidden in the vehicle, always remember that you install
a security system.
• Use a digital multimeter to identify each of the polarities of the wire, using a test light to locate the tach wire (if necessary).
• Please do not disconnect the battery if the vehicle has a radio code.
• If the vehicle is equipped with an airbag, do not disconnect the car battery or to connect without any certainty.
• Remove the fuse when you install the ceiling system to prevent draining the battery.
Humidity and condensation
• If the ambient temperature changes quickly, condensation may appear inside the monitor. The sytem returns to its original state after a
short time due to evaporation of moisture.
Multiplexed vehicles
The system installs on vehicles multiplexed. The only electrical connections required are:
• + 12V. (Permanent, post-contact reversing light)
• Ground
All this information is on regular wire at normal polarity (+ or -) which does not pass information encoded (multiplexed CANBUS, VAN or
other encoding). You should absolutely not cut or touch a coded wire (canbus).
IN ALL CASES, IT IS UNNECESSARY AND RECOMMENDED FOR CUTTING A THREAD OF ORIGIN OF THE VEHICLE. YOU MUST MAKE ONLY
ONE SPLICE AND RECOVER THE POSITIVE OR NEGATIVE SIGNAL PASSING THROUGH THIS THREAD.
BEEPER systems are fully compatible with the entire European car fleet and the installation can not cancel or modify the conditions of
the vehicle warranty. For information or advice, we ask that you contact our Technical Services (0892690792).
3. INSTALLATION OF THE SCREEN AND CAMERA
• Attaching the monitor & bracket :
1 • Attach the bracket with the lower adhesive
2 • Fix the monitor bracket using the screw #1
3 • Adjust the angle of the monitor you wish using the screw #2
• Attaching the Camera
1 • Loosen the side screws to remove the lower bracket of the camera
2 • Secure the bottom bracket to the rear of the vehicle
3 • Run the power wire inside the vehicle using the grommet to seal
4 • Screw the camera to the bracket by adjusting the optimal viewing angle
Screw 1
Screw 2
Paste
Side screws
RWEC99X version EN
P.8
Summary of Contents for RWEC99X
Page 2: ...professional...
Page 11: ...professional...