IMPORTANT INSTRUCTIONS
USER OPERATING MANUAL – MODEL 1222NA/2222EU
Revision 1.0
P a g e | 7
BEDJET REMOTE CONTROL SYNC TO BEDJET:
The wireless remote control needs to be
paired to your BedJet in order to correctly operate. This is normally done at the factor prior
to delivery. If BedJet is powered on (verified by Power LED on BedJet display) and wireless
remote control buttons are pressed (verified by LED indicator on remote) but the BedJet
does not activate, then re-pair the remote control to BedJet with the following procedure:
To pair your remote control to your BedJet, make sure BedJet is powered OFF for 10
seconds. Turn BedJet switch ON while simultaneously pressing and holding the COOL
Button on remote control until BedJet Power ON indicator lights. BedJet will make 3 fast
beeps to indicate successful pairing to remote. Only one remote can be paired to a BedJet
base unit at any given time. The pairing is permanent until a new remote control is paired.
BedJet VET Status Display:
Regular Display Messages:
Power LED ON = System ready
Heat Mode LED ON = Unit within 1.5°C of temperature set point
Heat Mode LED Blinking = Unit still adjusting to reach temperature set point
Problem Display Messages:
Power LED Blinking & 5 Beeps = System fault code, error or over temperature. Unit will
not be operational until powered off. If problem returns consult BedJet technical
support.
Air Flow Green LED Indicator is Rolling & Beeping = HEPA filter has reached 400 hours
accumulated operation, replace and reset HEPA filter hour counter (see page 11)
High Heat Mode ON
Medium & Custom Heat Mode
ON
Power ON
Bluetooth Smartlink
ON
Air Flow Level
