8 /31 EN
Refrigerator / User Manual
3
Installation
3.1. Appropriate location
for installation
Contact an Authorized Service for the installation
of the product. In order to prepare the product
for use, refer the information in the user manual
and ensure that electrical installation and water
installation are appropriate. If not, call a qualified
electrician and technician to have any necessary
arrangements carried out.
B
WARNING:
Manufacturer shall not
be held liable for damages that may
arise from procedures carried out by
unauthorized persons.
B
WARNING:
Product must not be plugged
in during installation. Otherwise, there is
the risk of death or serious injury!
A
WARNING:
: If the door clearance of the
room where the product shall be placed is
so tight to prevent passing of the product,
contact the authorized service.
• Place the product on a level floor surface to
prevent jolts.
• If you will use the product within a cabinet/
furniture, leave a clearance of minimum 2
cm between the side walls and the cabinet/
furniture.
• Install the product at least 30 cm away from
heat sources such as hobs, heater cores and
stoves and at least 5 cm away from electrical
ovens.
• Product must not be subjected to direct sun light
and kept in humid places.
• Appropriate air ventilation must be provided
around your product in order to achieve an
efficient operation. If the product is to be placed
in a recess in the wall, pay attention to leave
at least 5 cm distance with the ceiling and the
side walls.
For versions which do not have plastic
wedges, make sure that a clearance of 5 cm is
left from the rear wall.
•
In environments where the room temperature
drops below 10 °C, the refrigerator continues
to operate to preserve the food in the
freezer. However, the fresh food in the fridge
compartment may freeze due to the cold
environment.
3.2. Installing the plastic wedges
Plastic wedges supplied with the product are
used to create the distance for the air circulation
between the product and the rear wall.
1.
To install the wedges, remove the screws on the
product and use the screws supplied together with
the wedges.
2.
Insert the 2 plastic wedges onto the rear ventilation
cover as illustrated in the figure.
