10 /31 EN
Refrigerator / User Manual
4.1. Things to be done
for energy saving
mehmet
A
Connecting the product to electric energy
saving systems is risky as it may cause
damage on the product.
•
Do not leave the doors of your refrigerator open
for a long time.
•
Do not put hot food or drinks in your
refrigerator.
•
Do not overload the refrigerator, cooling
capacity will fall when the air circulation inside
is hindered.
•
To be able to store the maximum amount
of food in the freezer compartment of your
refrigerator, remove the icebox and the ice
container and place them on top of the glass
shelf. The power consumption stated for your
refrigerator was determined after removing
the icebox, ice container, and upper and
middle drawers to allow maximum loading.
Using the lower drawer while loading is highly
recommended.
•
Depending on the features of your product,
thawing frozen food in fridge compartment will
both provide energy saving and preserve the
food quality.
•
Airflow should not be blocked by placing foods
in front of the freezer compartment fan. Foods
should be loaded by leaving minimum 5 cm
space in front of the protective fan grid.
•
The temperature sensor in the freezer
compartment must be prevented from directly
contacting food packages. If they get in
contact, the power consumption of the product
may increase.
4
Preparation
C
Inside of your product must be cleaned.
C
If two coolers are to be installed side
by side, there should be at least 4 cm
distance between them.
4.2. Initial use
Before starting to use your refrigerator, ensure that
all preparations are made in accordance with the
instructions in sections "Instructions for safety and
environment" and "Installation".
Run the product without putting any food for 6 hours
and do not open its door unless certainly required.
C
You will hear a noise when the compressor
starts up. The liquids and gases sealed
within the refrigeration system may also
give rise to noise, even if the compressor is
not running and this is normal.
C
It is normal that the front edges of
the refrigerator are hot. These areas
are designed to be warm to avoid
condensation.
