Product overview
CX9020
12
Version: 2.0
4
Product overview
The CX9020 Embedded PC is a full-fledged PC with the following basic configuration:
• two MicroSD card slots,
• two switched Gbit-Ethernet interfaces,
• four USB 2.0 interfaces,
• and a DVI-D interface
The operating system is Microsoft Windows Embedded Compact 7.
The Embedded PC features internal persistent data memory in the form of 128 kB NOVRAM. In the event of
a power failure, important data are stored in the NOVRAM and are available again after a restart.
The CX9020 Embedded PC can be ordered ex factory with a 1-second UPS (CX9020-U900). The 1-second
UPS enables up to 1 MB of persistent data to be saved to the MicroSD card in the event of a loss of power.
The basic CPU module can be ordered ex factory with an optional interface. The optional interface cannot be
retrofitted.
Table 2: Available optional interfaces for the CX9020.
CX9020-xxxx Optional interfaces
CX9020-N020 Audio interface, 3 x 3.5 mm jack plug, Line-In, Mic-In, Line-Out
CX9020-N030 RS232, D-sub connector, 9-pin.
CX9020-N031 RS422/RS485, D-sub socket, 9-pin.
CX9020-B110 EtherCAT slave, EtherCAT IN and OUT (2 x RJ45).
CX9020-M310 PROFIBUS master, D-sub socket, 9-pin.
CX9020-B310 PROFIBUS slave, D-sub socket, 9-pin.
CX9020-M510 CANopen master, D-sub connector, 9-pin.
CX9020-B510 CANopen slave, D-sub connector, 9-pin.
CX9020-M930 PROFINET RT, controller, Ethernet (2 x RJ-45).
CX9020-B930 PROFINET RT, device, Ethernet (2 x RJ-45 switch).
CX9020-B950 EtherNet/IP Slave interface, Ethernet (2 RJ45 switches)
Power supply terminal
The power supply terminal for the Embedded PC is located on the right-hand side. Bus Terminals (K-bus) or
EtherCAT Terminals (E-bus) can be attached on the right-hand side of the power supply terminal. The power
supply terminal automatically recognizes the respective bus system (K-bus or E-bus).
Software
In combination with the TwinCAT automation software the CX9020 Embedded PC becomes a powerful IEC
61131-3 PLC. Up to four virtual IEC 61131-CPUs can each be programmed with up to four tasks. All IEC
61131-3 languages can be used.
Functions for Motion Control are also available, such as simple point-to-point movements.
In addition to real-time execution of control tasks, the TwinCAT real-time kernel ensures that enough time
remains for the user interface (HMI), to communicate with the real-time components via software interfaces
such as ADS or OPC.
Summary of Contents for CX9020
Page 1: ...Manual CX9020 Embedded PC 2 0 2019 04 09 Version Date ...
Page 2: ......
