Beckhoff CP29 Series, Manual

Page: 30 / 45

Commissioning
CP29xx 30 Version: 3.1
4.2.2 Installation in the control cabinet
Preparation of the control cabinet
The control cabinet must have the required installation cutout according to the device dimensions (see
Chapter 4.2.1
Dimensions [
}
29] ) of the Control Panel.
NOTE
Extreme environmental conditions
Extreme environmental conditions can cause damage to the device.
• Avoid extreme environmental conditions.
• Protect the device against dust, moisture and heat.
Please also note the following for installation in a control cabinet:
• Position the Control Panel such that reflections from light sources on the screen are avoided as far as
possible.
• For the correct installation height, use the position of the screen for guidance. This should always be
optimally visible to the user.
• Do not expose the Control Panel to direct sunlight.
Installation in the control cabinet
Once you have made the required cutout in the control cabinet, you can install the Control Panel in the
control cabinet. Clamping levers are provided at the back of the housing for final mounting of the device.
To install and secure the Control Panel in the control cabinet, follow the steps shown in Fig. 17:
1. Insert the Control Panel at the intended position in the panel of the control cabinet. Make sure that the
device is secured against falling out until it is fastened properly.
2. Loosen the clamping levers with a 3.0 mm Allen key (sections A and B).
3. Fold out the clamping levers 90° (section C).
4. Retighten the clamping levers with the Allen key (section D).
A B
C
D
Fig. 17: CP29xx_Control cabinet installation