Becker enocean P5-16, Assembly And Operating Instructions Manual

Page: 13 / 28

Programming transmitter
Put the tubular drive into programming mode.
3x 3x <2s
Press a travel button 3 times within two seconds.
▻ The tubular drive confirms.
► Programming is now complete.
Clear transmitter
Put the tubular drive into programming mode.
3x 3x <2s
Press a travel button 3 times within two seconds.
▻ The tubular drive confirms.
► The clearing process is now complete.
Checking that the running direction is correct
The direction of rotation can only be changed if no limit position has been set.
Press the UP or DOWN button
▻ The shading solution runs in the desired direction.
► Direction switch is OK.
If the shading solution runs in the wrong direction, the running direction must be switched. Proceed as follows:
Switch the direction switch (1) to the opposite position.
►
The shutter direction is now changed.
Check the shutter direction again.
Intelligent installation management
Completion of installation following automatic setting of limit positions
The drive saves the limit position permanently once the upper limit position is reached 3 times in succession. Installation is then
complete. If the limit position is set above a point, this is stored permanently.
Indicador de estado de las posiciones finales (IEPF)
A brief stopping and restarting indicates that no limit position has been set in that direction of movement.
Setting the limit positions
The running direction must be correct. When setting the limit positions, the tubular drive
runs in dead-man mode with the limit position status indicator. The upper limit position
must always be set first. When setting the upper limit position, ensure that the roller shut-
ter curtain is not pulled out of the guide tracks.
When first installing using springs and adjusting the limit position "...to lower stop", the
barrel in the lower limit position turns approx. 1/4 of a turn further than usual. In doing so,
the tubular drive is able to automatically detect the use of anti-lifting devices or springs.
The tubular drive switches off automatically.
13 - en