Becker Centronic / B-Tronic EasyControl EC715, Assembly And Operating Instructions Manual

Page: 63 / 144

Deleting the programming run on B-Tronic radio
receivers
Put the transmitter into master mode.
Select the receiver by pressing the button until the required receiver con-
firms.
All the following settings will then only be executed for this device.
Open/close the shading solution to a point
between the limit positions.
5s
Press the programming button and, within the
next 1 second, press the STOP button at the same
time and hold the two buttons down for 5 seconds.
▻
The receiver confirms.
► The programming run is now deleted.
Intermediate positions/tilt positions
The intermediate positions or tilt positions are freely select-
able positions for the shading solution or blind between the
two limit positions. Each travel button can be assigned one
intermediate position/tilt position. Both limit positions must
be set before an intermediate position is set.
When both or individual limit positions are deleted, both in-
termediate positions/tilt positions are deleted as well.
With external receivers it is possible to overwrite in any posi-
tion without deleting the previous position.
63 - en