Becker Centronic / B-Tronic EasyControl EC715, Assembly And Operating Instructions Manual

Page: 54 / 144

Putting the B-Tronic receiver into programming mode
•
Using a programmed B-Tronic transmitter
Put the transmitter into master mode.
Select the receiver by pressing the button until the desired receiver con-
firms.
All the following settings will then only be executed for this device.
Briefly press the programming button on the
transmitter.
▻ The receiver confirms.
► The receiver goes into the programming
mode for 3 minutes
• By switching on the voltage at the B-Tronic receiver
Switch on the power.
► The receiver goes into the programming
mode for 3 minutes
• With the radio switch on the B-Tronic tubular drive
Switch the radio switch to the inside position. If
the radio switch is already in this position, switch it
to the outside and back to the inside position.
► The tubular drive goes into the programming
mode for 3 minutes
• With the programming button on the B-Tronic radio receiver
3s
On the radio receiver
Press the programming button on the radio re-
ceiver for 3 seconds.
▻ The LED flashes green.
► The receiver goes into the programming
mode for 3 minutes
54 - en