Programming the first transmitter
The receiver mode must always be set appropriately for the
receiver. Roller shutter/venetian blind is the factory setting.
Putting the receiver into programming mode
Follow the Assembly and Operating Instructions for the re-
ceiver.
•
Switch off the power supply to the receiver for 5 seconds, then switch it
back on
or
•
Operate the programming button or the radio switch of the receiver.
The receiver is now in programming mode for 3 minutes.
Programming transmitters
Please make sure that only one receiver is in programming
mode at any time. It is not possible to program/clear multiple
receivers at the same time.
Press the transmitter's programming button while programming mode is act-
ive, until the receiver confirms successful programming. The status LED
flashes yellow during the programming process.
The programming process is now complete.
Lights up
green /
red
Action completed successfully (green) or not suc-
cessfully (red).
9
