Beastx MICROBEAST PLUS, Manual

Page: 254 / 353

Parameter explanation
Status-LED Slow rampup speed
purple 50 rps
red flashing 100 rps
red 200 rps
blue flashing 300 rps
blue 400 rps
With the StudioX software/StudioXm App you have the option to disable the softstart
feature, which will set the spool up rate to ”0”. This is necessary when using a speed
controler with built-in soft start feature (but without headspeed governing!).
In this
case the system will add half throttle immediately and wait until the speed controler has
finished the spool up. Then it will activate the governing.
Please note that you can't set a speed lower than 50 rps with StudioX because of
the fact noted above. Setting the speed below 50 will be the same as setting it to 0, so
it will disable the soft start!
106.9 Fast rampup speed (K)
When using the internal governor function and you change the head speed in the transmit-
ter in flight (i.e. by switching to a different flight mode), there will not be an abrupt change
but the system will increase the rotor rpm with a given rate that can be adjusted here.
This rate also determines how fast the rotor head speed will increase when reactivating the
Governor after an autorotation maneuver (Autorotation bailout). In this case, when the
heli is still in the air, the normal soft start (which is set at point J) would take way too
much time for the rotor to speed up again, so we use this faster spool up rate instead.
Status-LED Fast rampup speed
purple same as slow rampup speed (J)
red flashing 300 rps
red 500 rps
blue flashing 700 rps
blue 900 rps
246